Hi
I have a couple of niggling things that I would like to configure in my setup and haven't been able to find an answer through the forums:
1. After clicking on a thumbnail, the image name (.jpg) shows temporarily as the main image loads. Is is possible to disable this?
2. Is there a way to set the size of the description box?
3. I have three image folders grouped in a under a main folder so that when you click on Open Menu, it shows the single group folder name and then when you click on the group folder, you get to see the three image folders.
Main Menu >
Group Folder >
Folder 1
Folder 2
Folder 3
Is there a way to have the three image folder names show a click earlier - as in a drop-down straight from Open Menu and by-pass the click on the group folder?
Thanks.
Andrew
X3Photo Gallery Forums
X3 Photo Gallery Support Forums
Sounds like you have disabled the slideshow so that Imagevue displays images inside the static 640x360 size area? Perhaps you have a link to your gallery?
#1 That would only be if the above is true.
#2 The description "box" only appears if you are not using the slideshow. Unfortunately it can not be resized.
#3 YES - try setting "singlelevel = true" in your config.ini. It will skip the group folder click ...
#1 That would only be if the above is true.
#2 The description "box" only appears if you are not using the slideshow. Unfortunately it can not be resized.
#3 YES - try setting "singlelevel = true" in your config.ini. It will skip the group folder click ...
Hi Karl
Yes, Imagevue is sitting in a static size area:
http://www.milkins.com.au/iv.html
Can I achieve what I have done so far, plus fix the issues by using the Slideshow?
Regards
Andrew
Yes, Imagevue is sitting in a static size area:
http://www.milkins.com.au/iv.html
Can I achieve what I have done so far, plus fix the issues by using the Slideshow?
Regards
Andrew